Hello!
So i am using Lego NXT along with NXTBee and Bricxcc command center to program them. I am trying to get multiple robots to send information(mainly just number) and the XBee seem to work using XCTU software. However, when on NXT the receiver is not receiving correct i formation and the transmitter only sends certain number and cannot send “0” “3” “5” “6” “9”. Anyone knows possinle reasons?
The firmware is currently Znet 2.5 AT
I’m not sure I’m getting the problem you’re experiencing. Can you be more descriptive?
Also, we don’t deal with XBees or anything produced by Digi for that matter, so I don’t think this is the right forum to ask about help on this.
Thank you!